Pneumatic stand for vulcanizing thermopresses

Description

The device is designed to work with thermopress-type tire curing press, especially in case of frontal tire repairs. The stand is used during professional tire repair process. Its purpose is to make the installation of the tire curing press easier when repairing truck tires and to set the tire in a convenient position to repair it with the thermopress. The device is made of cold-formed steel sheet profiles electrically welded in a gas shield. It has been protected against corrosion and powder coated.

Features

• Thermopress mounting mandrel: makes the installation of the device easier
• Actuator control lever: makes it possible to raise the tire to the desired height
• Pneumatic actuator
• Device base: stabilises the device. Equipped with orifices for fixing to the floor
• Rollers: make it easier to set the tire and repair area in a correct position

Usage

• Install the thermopress on the stand - on the mandrel coming out of the base. The pneumatic actuator of the stand should be set in the down position
• Roll the tire onto the stand rollers
• Set the part of the tire that needs repairing to the 12 o'clock position
• Using the pneumatic lift lever manipulator of the stand, raise the unit until there is firm contact between the lower heater of the thermopress and the inside surface of the tire
• Repair according to the technology
• Once completed, lower the jack actuator

Technical data